xsavec

Performs a full or partial save of processor state components to the XSAVE area located at the memory address specified by the destination operand. The implicit EDX:EAX register pair specifies a 64-bit instruction mask. The specific state components saved correspond to the bits set in the requested-feature bitmap (RFBM), which is the logical-AND of EDX:EAX and XCR0. The format of the XSAVE area is detailed in Section 13.4, “XSAVE Area,” of Intel® 64 and IA-32 Architectures Software Developer’s Manual, Volume 1. Like FXRSTOR and FXSAVE, the memory format used for x87 state depends on a REX.W prefix; see Section 13.5.1, “x87 State” of Intel® 64 and IA-32 Architectures Software Developer’s Manual, Volume 1. Section 13.10, “Operation of XSAVEC,” of Intel® 64 and IA-32 Architectures Software Developer’s Manual, Volume 1 provides a detailed description of the operation of the XSAVEC instruction. The following items provide a highlevel outline: • Execution of XSAVEC is similar to that of XSAVE. XSAVEC differs from XSAVE in that it uses compaction and that it may use the init optimization. • XSAVEC saves state component i if and only if RFBM[i] = 1 and XINUSE[i] = 1.1 (XINUSE is a bitmap by which the processor tracks the status of various state components. See Section 13.6, “Processor Tracking of XSAVEManaged State” of Intel® 64 and IA-32 Architectures Software Developer’s Manual, Volume 1.) • XSAVEC does not modify bytes 511:464 of the legacy region of the XSAVE area (see Section 13.4.1, “Legacy Region of an XSAVE Area” of Intel® 64 and IA-32 Architectures Software Developer’s Manual, Volume 1). • XSAVEC writes the logical AND of RFBM and XINUSE to the XSTATE_BV field of the XSAVE header.2,3 (See Section 13.4.2, “XSAVE Header” of Intel® 64 and IA-32 Architectures Software Developer’s Manual, Volume 1.) XSAVEC sets bit 63 of the XCOMP_BV field and sets bits 62:0 of that field to RFBM[62:0]. XSAVEC does not write to any parts of the XSAVE header other than the XSTATE_BV and XCOMP_BV fields. • XSAVEC always uses the compacted format of the extended region of the XSAVE area (see Section 13.4.3, “Extended Region of an XSAVE Area” of Intel® 64 and IA-32 Architectures Software Developer’s Manual, Volume 1). Use of a destination operand not aligned to 64-byte boundary (in either 64-bit or 32-bit modes) results in a general-protection (#GP) exception. In 64-bit mode, the upper 32 bits of RDX and RAX are ignored. 1. There is an exception for state component 1 (SSE). MXCSR is part of SSE state, but XINUSE[1] may be 0 even if MXCSR does not have its initial value of 1F80H. In this case, XSAVEC saves SSE state as long as RFBM[1] = 1. 2. Unlike XSAVE and XSAVEOPT, XSAVEC clears bits in the XSTATE_BV field that correspond to bits that are clear in RFBM. 3. There is an exception for state component 1 (SSE). MXCSR is part of SSE state, but XINUSE[1] may be 0 even if MXCSR does not have its initial value of 1F80H. In this case, XSAVEC sets XSTATE_BV[1] to 1 as long as RFBM[1] = 1. XSAVEC—Save Processor Extended States With Compaction Vol. 2D 6-60

#GP(0) If a memory operand effective address is outside the CS, DS, ES, FS, or GS segment limit. If a memory operand is not aligned on a 64-byte boundary, regardless of segment. #SS(0) If a memory operand effective address is outside the SS segment limit. #PF(fault-code) If a page fault occurs. #NM If CR0.TS[bit 3] = 1. #UD If CPUID.01H:ECX.XSAVE[26] = 0 or CPUID.0DH.01H:EAX.XSAVEC[1] = 0. If CR4.OSXSAVE[bit 18] = 0. If the LOCK prefix is used. XSAVEC—Save Processor Extended States With Compaction Vol. 2D 6-61 #AC If this exception is disabled a general protection exception (#GP) is signaled if the memory operand is not aligned on a 64-byte boundary, as described above. If the alignment check exception (#AC) is enabled (and the CPL is 3), signaling of #AC is not guaranteed and may vary with implementation, as follows. In all implementations where #AC is not signaled, a general protection exception is signaled in its place. In addition, the width of the alignment check may also vary with implementation. For instance, for a given implementation, an align- ment check exception might be signaled for a 2-byte misalignment, whereas a general protec- tion exception might be signaled for all other misalignments (4-, 8-, or 16-byte misalignments).

#GP If a memory operand is not aligned on a 64-byte boundary, regardless of segment. If any part of the operand lies outside the effective address space from 0 to FFFFH. #NM If CR0.TS[bit 3] = 1. #UD If CPUID.01H:ECX.XSAVE[26] = 0 or CPUID.0DH.01H:EAX.XSAVEC[1] = 0. If CR4.OSXSAVE[bit 18] = 0. If the LOCK prefix is used.

Same exceptions as in protected mode.

Same exceptions as in protected mode.

#GP(0) If the memory address is in a non-canonical form. If a memory operand is not aligned on a 64-byte boundary, regardless of segment. #SS(0) If a memory address referencing the SS segment is in a non-canonical form. #PF(fault-code) If a page fault occurs. #NM If CR0.TS[bit 3] = 1. #UD If CPUID.01H:ECX.XSAVE[26] = 0 or CPUID.0DH.01H:EAX.XSAVEC[1] = 0. If CR4.OSXSAVE[bit 18] = 0. If the LOCK prefix is used. #AC If this exception is disabled a general protection exception (#GP) is signaled if the memory operand is not aligned on a 64-byte boundary, as described above. If the alignment check exception (#AC) is enabled (and the CPL is 3), signaling of #AC is not guaranteed and may vary with implementation, as follows. In all implementations where #AC is not signaled, a general protection exception is signaled in its place. In addition, the width of the alignment check may also vary with implementation. For instance, for a given implementation, an align- ment check exception might be signaled for a 2-byte misalignment, whereas a general protec- tion exception might be signaled for all other misalignments (4-, 8-, or 16-byte misalignments). XSAVEC—Save Processor Extended States With Compaction Vol. 2D 6-62